DIY Ballistic Knife Pen

here’s another office-supply weapon this
is the clip click ballistic pen it uses
the clip click brand pens that have a
specific type of firing mechanism for
using them you just press this down and
there’s the pen and then you press it
again and there’s two crevices so what
we want to do is plug up that second
crevice which will allow these this
shuttle to shoot out and that will be
your projectile now what I did I just
took a piece of the pen cartridge cut
that out and then glued it in place like
so right there
so what fits nice and perfect and stays
with a superglue so then took some duct
tape and glued I’m sorry duct taped a
spring to the bottom I use an extra
spring from another pen and intertwine
the two ends right here and then that
keeps this from coming out you put in
the projectile your click should you
click there you go and then fire so real
simple porks well you can make multiple
ones this one only has one needle what
you’ll need to do is drill out this top
of the cartridge I’m sorry the top of
the pen and that allows you to put more
needles this is three needles which kind
of give it more of a realistic look but
you don’t need to do this I just use
somes brush on super glue and tape to
keep them in place
and then this cap can be removed like so
and just all fits in right there so it
works real well
no problem simple project and don’t
bring this to school or anything but now
be safe have fun so
hopefully you guys get the time to try
this out it’s a real simple project if
you any questions you can leave me a
message otherwise on Facebook a lot so
if you guys want to go ahead and like my
page leave a few responses just comments
on what you want to see next and leave a
comment letting me know what you think
so that’s basically it thanks for
watching